Unix |
Unix v7 |
|
![]() |
stty(1) |
![]() |
stty − set terminal options
stty [ option ... ]
Stty sets certain I/O options on the current output terminal. With no argument, it reports the current settings of the options. The option strings are selected from the following set:
even |
allow even parity | ||
−even |
disallow even parity | ||
odd |
allow odd parity | ||
−odd |
disallow odd parity | ||
raw |
raw mode input (no erase, kill, interrupt, quit, EOT; parity bit passed back) | ||
−raw |
negate raw mode | ||
cooked |
same as ’−raw’ | ||
cbreak |
make each character available to read(2) as received; no erase and kill | ||
−cbreak |
make characters available to read only when newline is received | ||
−nl |
allow carriage return for new-line, and output CR-LF for carriage return or new-line | ||
nl |
accept only new-line to end lines | ||
echo |
echo back every character typed | ||
−echo |
do not echo characters | ||
lcase |
map upper case to lower case | ||
−lcase |
do not map case | ||
−tabs |
replace tabs by spaces when printing | ||
tabs |
preserve tabs | ||
ek |
reset erase and kill characters back to normal # and @ | ||
erase c |
set erase character to c. C can be of the form ’^X’ which is interpreted as a ’control X’. | ||
kill c |
set kill character to c. ’^X’ works here also. |
cr0 cr1 cr2 cr3
select style of delay for carriage return (see ioctl(2))
nl0 nl1 nl2 nl3
select style of delay for linefeed
tab0 tab1 tab2 tab3
select style of delay for tab
ff0 ff1 |
select style of delay for form feed | ||
bs0 bs1 |
select style of delay for backspace | ||
tty33 |
set all modes suitable for the Teletype Corporation Model 33 terminal. | ||
tty37 |
set all modes suitable for the Teletype Corporation Model 37 terminal. | ||
vt05 |
set all modes suitable for Digital Equipment Corp. VT05 terminal | ||
tn300 |
set all modes suitable for a General Electric TermiNet 300 | ||
ti700 |
set all modes suitable for Texas Instruments 700 series terminal | ||
tek |
set all modes suitable for Tektronix 4014 terminal | ||
hup |
hang up dataphone on last close. | ||
−hup |
do not hang up dataphone on last close. | ||
0 |
hang up phone line immediately |
50 75 110 134 150 200 300 600 1200 1800 2400 4800 9600 exta extb
Set terminal baud rate to the number given, if possible. (These are the speeds supported by the DH-11 interface).
ioctl(2), tabs(1)
![]() |
stty(1) | ![]() |