GNU/Linux man pages
Livre :
Expressions régulières,
Syntaxe et mise en oeuvre :
GNU/Linux |
RedHat 6.2(Zoot) |
|
 |
eiconctrl(8) |
 |
eiconctrl − configure Eicon.Diehl active ISDN adaptor
eiconctrl [-v] [-d Driver-Id] action options ...
eiconctrl is used to setup the Eicon.Diehl ISDN device driver and for downloading the firmware into the ISDN card.
The use of eiconctrl makes sense, if you are using an active Eicon.Diehl ISDN card only.
|
-v |
verbose during downloading the firmware. |
-d Driver-Id
selects the S0/S2M interface named by Driver-Id. Driver-Ids are defined during driver initialisation. See README.eicon for a description of the syntax to be used for modularised and monolithic driver versions. This option must be used to identify the S0/S2M interface if more than one S0/S2M interface is existent. If a single card is used, it may be omitted. If using more than one ISA-Bus-type card, support for the other cards is enabled with the add action of eiconctrl. PCI-Bus-type cards will be automatically added during driver initialisation. Ids may not start with digits or small x, because these values are misinterpreted as numeric parameters by insmod. For loading the module, always the newest modutils package should be used to avoid problems during load.
The following
actions may be given to eiconctrl.
irq [interrupt]
sets the irq number to use (only ISA). If the interrupt value is omitted, the current setting will be printed.
load protocol [options]
Downloads the protocol- and dsp-code into the card and starts operation.
protocol
etsi Euro-ISDN E-DSS1 (default)
1tr6 German ISDN Protocol
options
-l[channel#] channel allocation policy
-c[1|2] CRC4 Multiframe usage [off|on]
-tTEI use the fixed TEI
-h no HSCX 30 mode (PRI only)
-n NT2 mode
-p leased line D channel
-s[1|2] LAPD layer 2 session strategy
-o allow disordered info elements
-z switch to loopback mode
manage [read|exec <path>]
Starts Management-Interface.
xlog [cont]
Retrieving XLOG entries of adapter. With option cont given, it will be on a continuous cycle.
eiconctrl load etsi
loads and starts S0 type adapter with protocol E-DSS1.
eiconctrl load etsi -s2 -n
loads and starts S2M type adapter with protocol E-DSS1.
No bugs so far.
© 1999 by Armin Schindler <mac@melware.de>
isdnctrl(8), isdnctrl(4), ttyI(4), isdn_cause(7), isdninfo(4).
|
eiconctrl(8) | |