GNU/Linux man pages
Livre :
Expressions régulières,
Syntaxe et mise en oeuvre :
GNU/Linux |
RedHat 6.2(Zoot) |
|
 |
avmcapictrl(8) |
 |
avmcapictrl − Add AVM-B1 cards and load firmware
avmcapictrl add
<portbase> <irq> <type>
avmcapictrl load <bootcode> [<contrnr>
[<protocol>
[P2P | <dn1>:<spid1>
[<dn2>:<spid2>]]]]
avmcapictrl reset [contrnr]
avmcapictrl is used to register AVM-B1 ISA cards to the kernelcapi system and therewith to the isdn system. You need it also to upload the firmware to any AVM-B1 card.
The use of avmcapictrl makes sense, if you are using an AVM-B1-card only.
add <portbase> <irq> <type>
is used to add a card to the kernel-capi2.0 system. The portbase can have the values 0x150, 0x250, 0x300 and 0x340, look at the jumper on the card. The irq can be selected from the following values: 3, 4, 5, 6, 7, 9, 10, 11, 12 and 15. type can be B1 or T1.
load <bootcode> [<contrnr> [<protocol>
[P2P | <dn1>:<spid1> [<dn2>:<spid2>]]]] is used to load the firmware to a card bootcode is a t4-file. The actual versions of the t4-files for the different d-channel protocols can be found at ftp://calle.in-berlin.de/pub/linux/avmb1/firmware. you need different t4-files for different d channel protocols: b1-1tr6.t4 for 1TR6, b1.t4 for DSS1, D64S, D64S2, D64SD, DS01, DS02, CT1, VN3 or AUSTEL and b1-usa.t4 for 5ESS and NI1 (DSS1 is also supported). For M1/M2 PCMCIA cards you need m1-s10.t4 or m1-s4.t4 depending on the handy type used. contrnr is the number of the controller (card) starting from 1. protocol can be DSS1, D64S, D64S2, D64SD, DS01, DS02, CT1, VN3, AUSTEL, 5ESS or NI1. P2P point to point DN1:SPID1 DN2:SPID2 is for the american protocols 5ESS and NI1.
reset [contrnr]
is used to reset a card if loading has failed. This function only make sence if card is not successfully loaded. contrnr is the number of the controller (card) starting from 1.
Carsten Paeth <calle@calle.in-berlin.de>
ttyI(4), isdnctrl(8), isdninfo(4).
|
avmcapictrl(8) | |