GNU/Linux man pages
Livre :
Expressions régulières,
Syntaxe et mise en oeuvre :
GNU/Linux |
RedHat 6.2(Zoot) |
|
 |
readv(2) |
 |
readv, writev − read or write a vector
#include <sys/uio.h>
int readv(int fd, const struct iovec * vector, int count);
int writev(int fd, const struct iovec * vector, int count);
struct iovec
{
__ptr_t iov_base; /* Starting address. */
size_t iov_len; /* Length in bytes. */
};
readv reads data from file descriptor fd, and puts the result in the buffers described by vector. The number of buffers is specified by count. The buffers are filled in the order specified. Operates just like read except that data is put in vector instead of a contiguous buffer.
writev writes data to file descriptor fd, and from the buffers described by vector. The number of buffers is specified by count. The buffers are used in the order specified. Operates just like write except that data is taken from vector instead of a contiguous buffer.
On success readv returns the number of bytes read. On success writev returns the number of bytes written. On error, −1 is returned, and errno is set appropriately.
|
EINVAL |
An invalid argument was given. For instance count might be greater than MAX_IOVEC, or zero. fd could also be attached to an object which is unsuitable for reading (for readv) or writing (for writev). | ||
|
EFAULT |
"Segmentation fault." Most likely vector or some of the iov_base pointers points to memory that is not properly allocated. | ||
|
EBADF |
The file descriptor fd is not valid. | ||
|
EINTR |
The call was interrupted by a signal before any data was read/written. | ||
|
EAGAIN |
Non-blocking I/O has been selected using O_NONBLOCK and no data was immediately available for reading. (Or the file descriptor fd is for an object that is locked.) | ||
|
EISDIR |
fd refers to a directory. |
EOPNOTSUP
fd refers to a socket or device that does not support reading/writing.
|
ENOMEM |
Insufficient kernel memory was available. |
Other errors may occur, depending on the object connected to fd.
4.4BSD (the readv and writev functions first appeared in BSD 4.2), Unix98. Linux libc5 uses size_t as the type of the count parameter, which is logical but non-standard.
read(2), write(2), fprintf(3), fscanf(3)
|
readv(2) | |