GNU/Linux man pages
Livre :
Expressions régulières,
Syntaxe et mise en oeuvre :
GNU/Linux |
RedHat 5.2(Apollo) |
|
 |
testparm(1) |
 |
testparm − check an smbd configuration file for internal correctness
testparm [ configfilename [ hostname hostIP ] ]
This program is part of the Samba suite.
testparm is a very simple test program to check an smbd configuration file for internal correctness. If this program reports no problems, you can use the configuration file with confidence that smbd will successfully load the configuration file.
Note that this is NOT a guarantee that the services specified in the configuration file will be available or will operate as expected.
If the optional host name and host IP address are specified on the command line, this test program will run through the service entries reporting whether the specified host has access to each service.
configfilename
This is the name of the configuration file to check.
hostname
This is the name of the host to check access on.
If this parameter is supplied, the hostIP parameter must also be supplied, or strange things may happen.
hostIP
This is the IP number of the host specified in the previous parameter.
This number must be supplied if the hostname parameter is supplied, or strange things may happen.
smb.conf
This is usually the name of the configuration file used by smbd.
Not applicable.
The location of the server and its support files is a matter for individual system administrators. The following are thus suggestions only.
It is recommended that the testparm program be installed under the /usr/local/samba hierarchy, in a directory readable by all, writeable only by root. The program itself should be executable by all. The program should NOT be setuid or setgid!
This man page is (mostly) correct for version 1.9.00 of the Samba suite, plus some of the recent patches to it. These notes will necessarily lag behind development of the software, so it is possible that your version of the program has extensions or parameter semantics that differ from or are not covered by this man page. Please notify these to the address below for rectification.
smb.conf(5), smbd(8)
The program will issue a message saying whether the configuration file loaded OK or not. This message may be preceded by errors and warnings if the file did not load. If the file was loaded OK, the program then dumps all known service details to stdout.
If a host name is specified but no host IP number, all bets are off.
Other messages are self-explanatory.
None known.
The original Samba software and related utilities were created by Andrew Tridgell (samba-bugs@samba.anu.edu.au). Andrew is also the Keeper of the Source for this project.
The testparm program and this man page were written by Karl Auer. Bug reports to samba-bugs@samba.anu.edu.au.
See samba(7) for a full list of contributors and details on how to submit bug reports, comments etc.
|
testparm(1) | |