GNU/Linux man pages
Livre :
Expressions régulières,
Syntaxe et mise en oeuvre :
GNU/Linux |
CentOS 2.1AS(Slurm) |
|
 |
SSL_connect(3ssl) |
 |
SSL_connect − initiate the TLS/SSL handshake with an TLS/SSL server
#include <openssl/ssl.h> int SSL_connect(SSL *ssl);
SSL_connect() initiates the TLS/SSL handshake with a server. The communication channel must already have been set and assigned to the ssl by setting an underlying BIO.
The behaviour of SSL_connect() depends on the underlying BIO.
If the underlying BIO is blocking, SSL_connect() will only return once the handshake has been finished or an error occurred.
If the underlying BIO is non-blocking, SSL_connect() will also return when the underlying BIO could not satisfy the needs of SSL_connect() to continue the handshake. In this case a call to SSL_get_error() with the return value of SSL_connect() will yield SSL_ERROR_WANT_READ or SSL_ERROR_WANT_WRITE. The calling process then must repeat the call after taking appropriate action to satisfy the needs of SSL_connect(). The action depends on the underlying BIO. When using a non-blocking socket, nothing is to be done, but select() can be used to check for the required condition. When using a buffering BIO, like a BIO pair, data must be written into or retrieved out of the BIO before being able to continue.
When using a generic method (see SSL_CTX_new(3)), it is necessary to call SSL_set_connect_state(3) before calling SSL_connect() to explicitly switch the ssl to client mode.
The following return values can occur:
|
1 |
The TLS/SSL handshake was successfully completed, a TLS/SSL connection has been established. | ||
|
0 |
The TLS/SSL handshake was not successful but was shut down controlled and by the specifications of the TLS/SSL protocol. Call SSL_get_error() with the return value ret to find out the reason. | ||
|
<0 |
The TLS/SSL handshake was not successful, because a fatal error occurred either at the protocol level or a connection failure occurred. The shutdown was not clean. It can also occur of action is need to continue the operation for non-blocking BIOs. Call SSL_get_error() with the return value ret to find out the reason. |
SSL_get_error(3), SSL_accept(3), SSL_shutdown(3), ssl(3), bio(3), SSL_set_connect_state(3), SSL_CTX_new(3)
|
SSL_connect(3ssl) | |